How to Put Air in Tires

Ever wondered why your vehicle comes with a unique tire pressure recommendation? Every vehicle in Brooksville has a manufacturer-recommended tire pressure that enables it to provide a smooth and safe ride while conserving fuel. This is why if you have low tire pressure it’s important to fill your tires. Need to know how to put air in tires? The Plaza Chrysler Dodge Jeep Ram service team has you covered! Read on to learn how much air you should add to your tires and how to do it properly.

Adding Air to Tires: Step-by-Step Guide

Even if you’ve never adjusted your car’s tire pressure on your own, it’s not too hard if you have a guide. To add air to your tires, follow these steps below: 

• Pull up to the air dispenser at your local gas station. 
• Make sure you can reach all four tires with the air hose.
• Remove the cap from the tire valve on the first tire.
• Then, use your tire gauge to check the air pressure in the tire.
• Repeat this process for the other three tires. 

It’s worth noting that the air hose gauges at many gas stations aren’t 100% reliable. This is often due to the fact that driving causes the tires to heat and the inside to expand; this increases the tire pressure. Above all, you’ll want to avoid overinflating the tire. Use the air hose to add air in short bursts and make sure that — regardless of what the second reading is — you only top up what was lost before visiting the dispenser. 

If you do add too much air — don’t panic. Simply release some of the air. Press the pin on the tire valve with the back of the air hose nozzle, or use the small knob on the back of the rounded end of the tire gauge. And most importantly, don’t give up if you have to adjust the pressure more than a few times. It takes practice! 

How Much Air Should I Put in My Tires? 

You can find the recommended tire pressure for new CDJR vehicles shown on a sticker inside the driver’s door. If you’re unable to find a sticker, check the owner’s manual; there, you’ll find everything you need to know about your car’s tire pressure. Generally, passenger cars suggest 32 to 35 psi (pound per square inch) when they’re cold. To get the most accurate reading you can, check the tire pressure after the car has cooled off. When inflating your tires, keep the following in mind: 

• Don’t inflate your tires to the psi given on the actual tire. This number indicates the maximum amount of pressure the tire can hold — not its recommended psi. 
• You can usually tell that you’ve overinflated your tires when the ride quality is bouncy and the car is harder to handle. 
• Underinflated tires can lead to faster tire wear and tear.

Resetting Your Tire Pressure Light

After you properly inflate your tires, the tire pressure light should go off on its own. If it remains on, there are a few actions you can take:

• Drive at or above 50 mph to reset the sensor for 10 minutes. This can cause your sensor to reset the next time you turn on the car.
• With the vehicle off, turn the key to the “On” position, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The tire pressure monitor reset button is usually located beneath the steering wheel. If you can’t find it, check the user’s manual.
• Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well. Once they’re all deflated, reinflate to the recommended tire pressure.
• With the vehicle off, disconnect the positive battery cable with a wrench. Turn the car on and honk the horn for about three seconds. This will discharge any power still stored in the vehicle. Then reconnect the battery.

What Does a Flashing Tire Pressure Light Mean?

Tire pressure sensors often use a battery, and a flashing tire pressure light can often be a sign that the battery needs replaced. It could also indicate a problem with one of the sensors. Either way, you’ll want to schedule service at Plaza Chrysler Dodge Jeep Ram near Brooksville. We can diagnose the problem and get you back on the road safely.

Get Trusted Tire Service at Plaza Chrysler Dodge Jeep Ram

If you’re having tire troubles in Crystal River or you need routine maintenance like a tire rotation or wheel alignment, our service department is here for you! Book your appointment or contact us if you have questions. And don’t forget, our dealership makes it simple for Fruitland Park drivers to save on essential maintenance with ongoing MOPAR® service coupons!